ASTM A500 Steel Pipe Is Equivalent To Which Steel Grade?

Mar 06, 2024 Leave a message

The tensile strength of astm a500 is 400MPa, the yield strength is 290MPa, and the Chinese brand is: Q295B.
ASTM A500 equivalent parameters:
Tensile strength 400mpa
Yield strength 310mpa
Chemical composition: c 0.26, p 0.04, s 0.05
ASTM A500 Quality Standard for Cold Formed Welded and Seamless Carbon Steel Structural Pipes of Rounds and Sections
Circular structural pipe - For steel pipes with a specified outer diameter not greater than 1.9in (48.3mm), the change in the outer diameter shall not exceed 0.5%, and the specific value shall not exceed 0.005in (0.13mm). For steel pipes with a specified outer diameter less than 2.00in (50.8mm), the change in the outer diameter shall not exceed 0.75%, and the specific value shall not exceed 0.005in (0.13mm). The outside diameter shall be measured at least 2 inches (50.8 mm) from the end of the pipe.
Square rectangular pipe - the outer diameter is measured at least 2 inches (50.8mm) away from the pipe end. The difference between the outer diameter of the steel pipe and the specified outer diameter shall not exceed the change in outer diameter specified in Table 3, where the outer diameter Variations include bulges and depressions. Wall Thickness - The minimum wall thickness measured at any point on the steel pipe, which shall not vary by more than 10% from the specified wall thickness. The maximum wall thickness measured at any point on the steel pipe, including the value measured at the weld, shall not vary by more than 10% from the specified wall thickness. For square and rectangular tubes, the wall thickness requirements are limited to the middle part.
Length - The structural steel pipes produced are generally any length above 1.5 meters, various or fixed. Refer to Part 4. When the customer specifies a specific length, the length limit shall comply with the requirements of Table 4.
Straightness - The allowable variation in straightness of structural steel pipes is 10.4mm times 1/5 of the total length of the steel pipe in meters.
Angle - the two adjacent sides of a square rectangular steel pipe should be 90 degrees, and the maximum allowable change should not exceed 2 degrees.

ASTM A500 steel pipe